Mi Redmi Note 5 M1803E7SG Firmware Frp Mi Account Remove File Tool [WORK]

How to Remove FRP and Mi Account from Mi Redmi Note 5 M1803E7SG

If you have a Mi Redmi Note 5 M1803E7SG smartphone and you want to remove the FRP (Factory Reset Protection) and Mi Account lock from it, then you are in the right place. In this article, we will show you how to use a firmware file and a tool to bypass these security features and restore your device to its original state.

FRP and Mi Account are two security features that prevent unauthorized access to your device after a factory reset. FRP is a Google feature that requires you to enter the Google account that was previously synced with your device. Mi Account is a Xiaomi feature that requires you to enter the Mi account that was previously linked with your device. If you forget or lose these credentials, you will not be able to use your device normally.

Fortunately, there is a way to remove FRP and Mi Account from your Mi Redmi Note 5 M1803E7SG using a firmware file and a tool. The firmware file is a flashable zip file that contains the official stock ROM for your device. The tool is a software application that can flash the firmware file to your device and remove the FRP and Mi Account lock.

Requirements

A Mi Redmi Note 5 M1803E7SG smartphone with at least 50% battery charge.

A USB cable to connect your device to your computer.

A Windows PC with the latest drivers installed for your device.

The firmware file for your device model. You can download it from here.

The tool to flash the firmware file. You can download it from here.

Steps

Extract the firmware file and the tool to separate folders on your computer.

Run the tool as administrator and click on \"Select\" to browse and select the firmware file.

Turn off your device and boot it into fastboot mode by pressing and holding the Volume Down and Power buttons together for a few seconds.

Connect your device to your computer using the USB cable. The tool should detect your device and show its serial number.

Click on \"Refresh\" to confirm that your device is connected properly.

Click on \"Flash\" to start flashing the firmware file to your device. Wait for the process to complete. It may take several minutes.

Once the flashing is done, disconnect your device from your computer and reboot it normally.

Your device should now boot up without asking for FRP or Mi Account verification. You can set up your device as new or restore it from a backup.

Congratulations! You have successfully removed FRP and Mi Account from your Mi Redmi Note 5 M1803E7SG smartphone using a firmware file and a tool. If you have any questions or issues, feel free to leave a comment below. 248dff8e21